Preamp Parameters - Roland Sonar V-Studio VS-700 Owner's Manual

Preamp Parameters

Preamps are built into the eight audio inputs (INPUT 1–8).
If you're using SONAR, you can edit the preamp parameters as described below.
If you're using software other than SONAR, use "VS-700R I/O Editor" which is included on the "SONAR V-
STUDIO 700 CD-ROM."
1.
From SONAR's "Tools" menu, open "VS-700."
2.
Select the "MIC PRE" tab.
3.
Apply the desired preamp settings.
These settings are not stored in the VS-700.
Setting
Low cut
Phase
PAD
Input gain
Stereo link
You can use the channel strip rotary encoders to control the Mic Pre Gain, Threshold ,Attack and Release
parameters on the VS-700R I/O. For details, refer to "I/O Control" (p. 44).
84
Screen label Range
OFF, ON
Normal
(normal
phase),
Invert (reverse
phase)
OFF, ON
0–+44 dB
OFF, ON
Default Explanation
Enables the low cut filter for the input. The cutoff
OFF
frequency is 100 Hz.
Normal Inverts the polarity of the input signal.
ON Attenuates the input signal by 20 dB.
Adjusts the gain of the input signal in a range of 0–
0
44 dB. The adjustment is in 1 dB steps.
If this setting is on, the preamp and compressor
OFF settings of the adjacent even-numbered channel
will be the same as this channel.