System Control - Roland Sonar V-Studio VS-700 Owner's Manual

System Settings

System Control

Parameter
Source 1–4
System Control
This function, which departs from previously used methods, and instead allows you to use MIDI messages to change tone settings
in realtime, is called the Matrix Control (p. 121). Similarly, the function allowing you to use MIDI messages to change multi-effects
settings in realtime is called the Multi-effects Control (p. 149).
Normally, the Matrix Control is used for making patch settings, and the Multi-effects Control for making settings to patches,
rhythm sets, and performances. However, if you do not need to change the MIDI messages used for matrix control or multi-effects
control by each patch/rhythm set/performance, or if you want to use a specific MIDI message for matrix control or multi-effects
control, you will want to make use of System Control. In other words, you could call the System Controls global Matrix Control/
Multi-effects Control for the entire Fantom VS.
You can use up to four System Controls.
152
Value Description
System Control Assign selects the MIDI message used as the System Control.
OFF,
OFF:
CC01–31, 33–95,
CC01–31, 33–95: Controller numbers 1–31, 33–95
PITCH BEND
PITCH BEND:
AFTERTOUCH
AFTERTOUCH:
The system control knob will not be used.
Pitch Bend
Aftertouch