Compressor Parameters - Roland Sonar V-Studio VS-700 Owner's Manual

Compressor Parameters

Digital compressors are built into the eight audio inputs (INPUT 1–8).
If you're using SONAR, you can edit the compressor parameters as described below.
If you're using software other than SONAR, use "VS-700R I/O Editor" which is included on the "SONAR V-
STUDIO 700 CD-ROM."
1.
From SONAR's "Tools" menu, open "VS-700."
2.
Select the "MIC PRE" tab.
3.
Apply the desired compressor settings.
These settings are not stored in the VS-700.
Setting Screen label
Comp switch COMP
Threshold THRES
Ratio RATIO
Attack time ATK
Release time REL
Gain GAIN
You can use the channel strip rotary encoders to control the Mic Pre Gain, Threshold ,Attack and Release
parameters on the VS-700R I/O. For details, refer to "I/O Control" (p. 44).
Range Default
OFF, ON OFF
-60–0 dB -20 dB
1:1.0,
1:1.1,
1:1.2,
1:1.4,
1:1.6,
1:1.8,
1:2.0,
1:4.0
1:2.5,
1:3.2,
1:4.0,
1:5.6,
1:8.0,
1:16,
1:INF
0–100
0–100
-30–30 dB 0 dB
Explanation
Enables the compressor.
Specifies the signal level at which the compressor
will be applied.
Specifies the compression ratio by which the
audio signal will be compressed.
Actual value (0.2–100 ms)
Actual value (10–500 ms)
Adjusts the output level of the compressor.
85