Select Mode - Roland Sonar V-Studio VS-700 Owner's Manual

Select Mode

Select mode lets you use the Jog/Shuttle wheel to select clips or arbitrary sections of time within a clip or across
multiple clips. The selection can then be edited in Edit mode.
There are two different selection modes:
Mode
Select by Time mode
Select by Clip mode
To enable Select by Time mode (default)
Press [SELECT] button. The [SELECT] button will be lit solid to indicate this mode.
To enable Select by Clip mode
Press [SHIFT]+[SELECT] button. The [SELECT] button blinks when select by clip mode is enabled.
In Select mode, the modifier buttons (p. 67) can be used to extend the functions as follows.
Button
Jog/Shuttle
Up/Down
cursors
Left/Right
cursors
SELECT
You cannot select discontinuous clips across different tracks. Clip select will not loop the screen when selection
reaches the end of the project. Selection will end.
To clear the selection:
Push and hold the [LEFT FLAG] button
Explanation
This mode lets you use the Free Edit Tool to select by time. In this mode, the [SELECT]
button is lit.
This mode lets you use the Free Edit Tool to select data by clip. In this mode, the [SELECT]
button blinks.
Default function SHIFT+
Move Free Edit
Move Free Edit
Cursor by clips,
Cursor horizontally
selecting whole clip.
Move Free Edit
Move Free Edit Cursor vertically by
Cursor vertically clips, selecting
whole clip.
Move Free Edit
Move Free Edit Cursor horizontally
Cursor horizontally by clips, selecting
whole clip.
Enable Move mode (Reserved)
, then push the [RIGHT FLAG] button
JOG/SHUTTLE/CURSOR Section
CTRL+ ALT+
Make a time range
Move Free Edit
selection using the
Cursor vertically
Free Edit Cursor
Make a time range
(Reserved) selection using the
Free Edit Cursor
Make a time range
(Reserved) selection using the
Free Edit Cursor
Center Free Edit Move Free Edit
Cursor Cursor to Now Time
.
61