Adjusting The Volume (Tva/Tva Env) - Roland Sonar V-Studio VS-700 Owner's Manual

F-Env T4 V-Sens
(TVF Envelope Time 4 Velocity Sensitivity)
The parameter to use when you want key release speed to
control the Time 4 value of the TVF envelope. If you want
Time 4 to be speeded up for quickly released notes, set this
parameter to a positive (+) value. If you want it to be slowed
down, set this to a negative (-) value.
Value: -63– +63
F-Env Time 1–4 (TVF Envelope Time 1–4)
Specify the TVF envelope times (Time 1– Time 4). Higher
settings will lengthen the time until the next cutoff frequency
level is reached. (For example, Time 2 is the time over which
Level 1 will change to Level 2.)
Value: 0–127
F-Env Level 0–4 (TVF Envelope Level 0–4)
Specify the TVF envelope levels (Level 0–Level 4). These
settings specify how the cutoff frequency will change at each
point, relative to the standard cutoff frequency (the cutoff
frequency value specified in the TVF screen).
Value: 0–127
fig.06-037.e
T1 T2
Cutoff
Frequency
L0
L2
L1
Note on
T: Time L: Level
T3 T4
Time
L3 L4
Note off

Adjusting the Volume (TVA/TVA Env)

Rhythm TVA
Tone Level (Rhythm Tone level)
Sets the volume of the rhythm tone. Use this parameter to
adjust the volume balance between rhythm tones.
Value: 0–127
The volume levels of the Waves from which the rhythm
tone is composed is set with the WMT1–4 Wave Level
parameter (p. 128).
Level V-Curve (Level Velocity Curve)
You can select from seven curves that determine how
keyboard playing strength will affect the volume. If you do
not want the volume of the rhythm tone to be affected by
the force with which you press the key, select "FIXED."
Value: FIXED, 1–7
fig.06-036
1 2 3
Level V-Sens (Level Velocity Sensitivity)
Set this when you want the volume of the rhythm tone to
change depending on the force with which you press the
keys. Set this to a positive (+) value to have the changes in
rhythm tone volume increase the more forcefully the keys are
played; to make the tone play more softly as you play harder,
set this to a negative (-) value.
Value: -63– +63
Tone Pan (Rhythm Tone Pan)
Sets the pan for the rhythm tone. "L64" is far left, "0" is center,
and "63R" is far right.
Value: L64–0–63R
Set the Pan for Waves comprising the rhythm tones with
the Wave Pan parameter (p. 128).
Creating a Rhythm Set
4 5 6 7
133