Scale Tune Settings; Parameter List; Part Velocity Sensitivity Offset; Part Pitch Bend Range - Roland Sonar V-Studio VS-700 Owner's Manual

Cakewalk by roland sonar v-studio mixer owner's manual

Table of Contents

Part Velocity Sensitivity Offset

This changes the volume and cutoff frequency for each part

according to the velocity with which the keys are pressed. If

you want strongly played notes to raise the volume/cutoff

frequency, set this parameter to positive (+) settings. If you

want strongly played notes to lower the volume/cutoff

frequency, use negative (-) settings. Set Velocity Sensitivity to

"0" when you want sounds played at a fixed volume and

cutoff frequency, regardless of the force with which the keys

are played.

Value:

-63– +63

Patches also contain a Velocity Sensitivity Offset setting

(p. 99). The ultimate Velocity Sensitivity Offset value is

the sum of the part's and the patch's Velocity Sensitivity

Offsets. Accordingly, if the patch's Velocity Sensitivity

Offset parameter is set to "127" (maximum), there will

be no change in the part's Velocity Sensitivity Offset,

even when this is set to a positive value.

Part Pitch Bend Range

Specifies the amount of pitch change in semitones (2

octaves) that will occur when the Pitch Bend Lever is moved.

The amount of change when the lever is tilted is set to the

same value for both left and right sides. If you want to use the

Pitch Bend Range setting of the patch assigned to the part (p.

108), set this to "PAT."

Value:

0–24, PAT

Receive Switch (Part Receive Switch)

For each part, specify whether MIDI messages will be

received (ON), or not (OFF).

If this is "OFF," the part will not respond. Normally, you

should leave this "ON," but you can turn it "OFF" when you do

not want a specific part to be playing during song playback.

Value:

OFF, ON