Roland Sonar V-Studio VS-700 Owner's Manual page 157

4.
Insert the board into the VS-700R's non-latched board holders until you hear a click.
fig.attach02.eps
Connector
of board
Connector
of the VS-700R
5.
Gently lower the board into place.
fig.attach04.eps
6.
From above, press down on the board at the three locations indicated in the illustration until the
latched board holders lock into place.
fig.attach06.eps
Edge of the board
where the logo
is affixed
Near the cutouts
in the board
7.
Verify that the latched board holders are locked.
fig.attach07.eps
8.
Use the screws that you removed in step 2 to fasten the cover back in place.
Board
Align board's
holes with holders
Non-latched holders
Installing the ARX Expansion Board
157