Changing How A Tone Is Sounded (Tmt) - Roland Sonar V-Studio VS-700 Owner's Manual

Changing How a Tone Is Sounded (TMT)

You can use the force with which keys are played, or MIDI
messages to control the way each Tone is played. This is
referred to as the Tone Mix Table (TMT).
For details on these settings, refer to How to Make
Patch Settings (p. 96).
Patch TMT
Structure Type 1 & 2, 3 & 4
Determines how tone 1 and 2, or tone 3 and 4 are connected.
Value: 1–10
The following 10 different Types of combination are
available.
fig.06-014
TYPE 1
TONE 1 (3) WG
TONE 2 (4) WG
With this type, tones 1 and 2 (or 3 and 4) are independent.
Use this type when you want to preserve PCM sounds or
create and combine sounds for each tone.
fig.06-015
TYPE 2
TONE 1 (3) WG TVA
TONE 2 (4) WG
This type stacks the two filters together to intensify the
characteristics of the filters. The TVA for tone 1 (or 3) controls
the volume balance between the two tones.
TVF TVA
TVF TVA
TVF
TVF TVA
fig.06-016
TYPE 3
TONE 1 (3) WG
TVA
TONE 2 (4) WG
This type mixes the sound of tone 1 (3) and tone 2 (4), applies
a filter, and then applies a booster to distort the waveform.
fig.06-017
TYPE 4
TONE 1 (3) WG TVA
TONE 2 (4) WG
This type applies a booster to distort the waveform, and then
combines the two filters. The TVA for tone 1 (or 3) controls
the volume balance between the two tones and adjusts
booster level.
fig.06-018
TYPE 5
TONE 1 (3) WG TVA
TONE 2 (4) WG
This type uses a ring modulator to create new overtones, and
combines the two filters. The tone 1 (3) TVA will control the
volume balance of the two tones, adjusting the depth of ring
modulator.
fig.06-019
TYPE 6
TONE 1 (3) WG TVA
TONE 2 (4) WG
This type uses a ring modulator to create new overtones, and
in addition mixes in the sound of tone 2 (4) and stacks the
two filters. Since the ring-modulated sound can be mixed
with tone 2 (4), tone 1 (3) TVA can adjust the amount of the
ring-modulated sound.
Creating a Patch
TVF
B
TVF TVA
TVF
B
TVF TVA
TVF
R
TVF TVA
TVF
R
TVF TVA
101