Honeywell Touchpoint Pro Technical Handbook page 81

9.2.22 Inhibit Signalling Settings
Access Level: Engineer
Parameter Name
Inhibit Signalling
Enable
Inhibit Level Max
Inhibit Level Min
9.2.23 Fault Signalling Settings 1
Access Level: Engineer
Parameter Name
Custom Event 1
Enable
Custom Event 2
Enable
Custom Event 3
Enable
9.2.24 Fault Signalling Settings 2
Access Level: Engineer
Parameter Name
Custom Event 4 Enable
Custom Event 5 Enable
Part. No. 2400M2501_6
CONFIGURATION
Default Value Range
Setting
Disabled Enabled /
Disabled
1.0 mA 1.0 to 3.9 mA
2.0 mA 0.8 to 3.9 mA
Default Value Range
Setting
Disabled Enabled /
Disabled
Disabled Enabled /
Disabled
Disabled Enabled /
Disabled
Default Setting Value Range
Disabled Enabled /
Disabled
Disabled Enabled /
Disabled
Comment
If enabled, a specific signal level from the sensor will
activate an inhibit condition for the channel.
The recommended minimum difference between Inhibit
Level Max and Inhibit Level Min is 0.2 mA
Comment
If enabled, a specific signal level from the sensor will
activate a custom fault condition for the channel. An
example of a custom fault is the 'Beam Block' condition
for an open path IR detector
Comment
If enabled, a specific signal level from the sensor
will activate a custom fault condition for the
channel. An example of a custom fault is the
'Beam Block' condition for an open path IR
detector
74
Touchpoint Pro
Technical Handbook