Tppr Safety Function; Touchscreen Operation; Table 37. System Alert Icons - Honeywell Touchpoint Pro Technical Handbook

13.4 TPPR Safety Function

During normal Day-to-Day operation:

The TPPR system will collect data every 250 ms from all of the Input/Output modules on the Ring Network

The Cause and Effect matrix will be evaluated every 250 ms, and commands sent accordingly to the appropriate
output channels. System response time for AIM is ≤3 s and ≤1 s for DIM

Any change in status of an I/O channel will be reported to the User Interface and logged in the event history

Any occurrence of any of the events listed in Chapter 18 Error Codes will be reported on the User Interface and
logged in the event history

Any system fault or inhibit will cause the System Fault relay to open

Any failure of the safety function e.g. due to major fault or power loss will cause the System Failure relay to open

13.5 Touchscreen Operation

During normal operation the Touchscreen should show a menu bar at the top and a green tick on the main screen below it.
During active events the status changes and an alarm may sound.
Users may touch the screen to show further menus or descriptions (some menus require password access).
A table of icons is given at Chapter 24.
13.5.1 System Status Screen Alert Icons
The System Status screen provides a summary of the TPPR status using Alert Icons accompanied by the text in bold:
Part. No. 2400M2501_6
NORMAL OPERATION
High 'off-scale' readings may indicate an explosive concentration.
Des résultats dépassant considérablement l'échelle peuvent être indicateurs d'une
System OK
All input and output
channels are Normal
Alarm
One or more input channels
are in Alarm
Warning
One or more Warnings are
active

Table 37. System Alert Icons

WARNING
AVERTISSEMENT
concentration explosive.
Fault
One or more channels are
in Fault
Inhibit
One or more channels are
in Inhibit
108
Touchpoint Pro
Technical Handbook