The "Upload Mode" For The Display Unit; (Rheowin 2.6 Or Higher) - Thermo Scientific HAAKE RotoVisco 1 Instruction Manual

Operating

10.4 The "Upload Mode" for the Display Unit

(RheoWin 2.6 or higher)

The rheometers can be operated by the software RheoWin
in "direct mode" or it can be loaded by special functions mea-
suring programs in the store of the measuring device. By
that, the measuring device gets independent of the PC and
it is only connected for programming or data transfer. The
measuring programs ("JOBs") are started after the corre-
sponding programming with the display unit.
For programming or data transfer the Rheometer must be
connected to the PC via RS232 cable as usual and Thermo
Fisher Scientific Haake software RheoWin must be loaded.
After installing the rheometer two versions per model can be
found in the device manager . The device e.g. RotoVisco1
is running in the software direct mode as usual. Model RV1
(Upload mode) has already been pre--defined as indepen-
dent device.
The characteristic "Upload Mode" is transferred to the device
driver on the following card which can be found under "Edit".
So you can give the device driver the characteristic "Upload"
or "Software" mode. For practical reason it is advisable to de-
fine a new device for each operation.
46