Baldor FPX A05T Installation & Operating Manual page 39

Windows 95
Windows NT
5-2 Operation
Select "Binary Transfers" from the Settings pull down menu within
5.
Terminal program.
Set the Binary Transfer protocol to XModem/CRC.
6.
Close menu and save the settings.
7.
Terminal Communications settings are now complete.
8.
1. Power up the Host and start Windows software.
2. In "Control Panel" select and open "System".
3. Open "Ports", select the COM port you are using then click "properties".
Figure 5-2
4. Be sure the port settings are as: Bits per second=9600, Data bits=8,
Parity=none, Stop bits=1 and Flow control=Xon/Xoff.
1. Power up the Host and start Windows software.
2. In "Control Panel", select and open "Ports" then click "Settings".
Figure 5-3
3. Be sure the port settings are as: Bits per second=9600, Data bits=8,
Parity=none, Stop bits=1 and Flow control=Xon/Xoff.
MN1276