Baldor FPX A05T Installation & Operating Manual page 100

X1 Possible Faults -- Continued
X1 Fault Display
12 "FAULT_RELAY"
13 "EAF"
14 "MISSING INT"
15 "POWER_ID"
16 "CW_CCW"
17 "DESIGN_FAILURE"
18 "EE_CLEARED"
19 "EE_INTEGRITY"
20 "EAF Drive Temp"
21 "EAF Motor Temp"
22 "EAF Drive I2T"
23 "EAF Motor I2T"
Methods:
Command Description
FRST Resets system faults if allowed. Reset is not allowed, if
error is still pending.
LOGRST Resets system fault log
Communication Settings
Parameter:
Command Description
ECHO Disable / enable echoing for input
characters
PROMPT Enables / disables terminal prompt
TALK Enables / Disables terminal error
notification
Variable:
Command Description
COM.STTS Queries the most recent communication
handler error
Methods:
Command Description
B Opens communication to the drive, called by its address
(the addresses a constant, which can be queried by
COM.ADDR or SYS.STTS)
MN1276
Description
when fault relay is closed. Displays '9'.
N.I
N.I
DRV.ID != SYS.POWER. Displays small 'u'.
Both limit switches are on. Displays 'L'.
Control design fail. Displays small 'c'.
EEPROM header stamp was not detected.
Displays big 'U'
EEPROM footer stamp was not detected. Displays big 'A'.
EAF drive over temperature error. Displays '6'.
EAF motor over temperature error. Displays '6'.
2
EAF drive I T error. Displays '6'.
2
EAF motor I T error. Displays '6'.
Parameter
--
--
Units Range
-- "ON/OFF
-- "ON/OFF
-- "ON/OFF
Units Range
-- 0:65535
Parameter
Address
Units Range
-- --
-- --
Default E / Par. set
2
"ON" -- / --
"ON" -- / --
"ON" -- / --
Default E / Par. set
2
-- / --
Units Range
-- 0 : 7
Command Set B-9