Factory Installed Settings; Move To Buffer 1 Position - Baldor FPX A05T Installation & Operating Manual

Factory Installed Settings

15 predefined absolute moves have been programmed at the factory. These
moves are defined in Table 3-5.
Table 3-5 Machine Inputs and Position Move Definitions
Buffer Buffer
(Move Number)
MAI4
0 (Home) OFF
1 OFF
2 OFF
3 OFF
4 OFF
5 OFF
6 OFF
7 OFF
8 ON
9 ON
10 ON
11 ON
12 ON
13 ON
14 ON
15 ON
Note: The machine Inputs of Table 3-5 are "OFF" when the switch is open.

Move to Buffer 1 Position

Note: To stop a move before it has completed, disable the drive (Enable input = Open)
This completes an absolute move to buffer 1 position. Use switches MAI1 -- 4 to
select other move numbers and use the Trigger switch to begin each move.
Note: If the motor is already at buffer 1 position, commanding another absolute
MN1276
Absolute moves
Machine Inputs
MAI3 MAI1
OFF OFF
OFF ON
OFF OFF
OFF ON
ON OFF
ON ON
ON OFF
ON ON
OFF OFF
OFF ON
OFF OFF
OFF ON
ON OFF
ON ON
ON OFF
ON ON
Therefore, when MAI1 -- 4 are open, move number 0 (Home) is selected.
(Absolute move to position 100000).
or Reset the drive (Reset input = closed then open) or Quit (Quit input = closed
then open).
1. Open MAI1 -- 4 inputs (position 0 select).
2. Enable the drive.
3. Close MAI1 input.
4. Close the Trigger input. Motor immediately moves to position 100000.
5. Open the Trigger input.
move to the same position will not cause the motor shaft to rotate.
Therefore, command a move to a different absolute position before
commanding another move to buffer 1 position.
Position Position
MAI2
OFF 0
OFF 100000
ON 200000
ON 300000
OFF 400000
OFF 500000
ON 600000
ON 700000
OFF 800000
OFF 900000
ON 1000000
ON 1100000
OFF 1200000
OFF 1300000
ON 1400000
ON 1500000
Speed Speed Acceleration Acceleration
(RPM) (RPM / ms)
100 40
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
2000 300
Receiving & Installation 3-15