Baldor FPX A05T Installation & Operating Manual page 17

Figure 3-5 Single Phase AC Power Connections (FP1AxxT & FP2AxxT only)
L1
Note 1
* Circuit
Breaker
Note 2
L
For CE Compliance, refer to Section 8 of this manual.
Figure 3-6 Single Phase AC Power Connections (FP1AxxS only)
L1
Note 1 * Circuit
Breaker
Note 2
L1
For CE Compliance, refer to Section 8 of this manual.
Note: These Flex+Drive versions are not designed for use with 400/460VAC
3-6 Receiving & Installation
L2
Earth
Note 3 & 4
N
Notes:
Baldor
1.
Control
2.
3.
4.
L2
Earth
Note 3 & 4
L2 L3 PE
Notes:
Baldor
1.
Control
2.
3.
4.
connections.
L1
Alternate *
Fuse
Connection
*
Components not provided with Control.
See "Protection Devices" described in this section.
Metal conduit or shielded cable should be used. Connect
conduits so the use of a Reactor or RC Device does not
interrupt EMI/RFI shielding.
Use same gauge wire for Earth ground as is used for L and N.
(VDE (Germany) requires 10mm
Compliance, connect to the backplane of the enclosure.
Reference EMC wiring in Section 8.
L1
Alternate *
Fuse
Connection
*
Components not provided with Control.
See "Protection Devices" described in this section.
Metal conduit or shielded cable should be used. Connect
conduits so the use of a Reactor or RC Device does not
interrupt EMI/RFI shielding.
Use same gauge wire for Earth ground as is used for L and N.
(VDE (Germany) requires 10mm
Compliance, connect to the backplane of the enclosure.
Reference EMC wiring in Section 8.
L2
Note 1
2
minimum). For CE
L2
Note 1
2
minimum). For CE
MN1276