Alarm - EverFocus VANGUARD 16x8 User Manual

VANGUARD 16x8 / VANGUARD 8x4 / VANGUARD 4x2

4.1.1.5.2 Alarm

You can configure the Alarm setting on this page.
Alarm In: Select an alarm input from the drop-down list.
Alarm Type: Select an alarm type. N.O or N.C. If you want to disable the alarm, select Off.
Alarm Output: Set up an alarm output time (duration) when an alarm is triggered.
Buzzer: Set up the time for DVR buzzer to sound when an alarm is triggered.
Post Recording: Select a post recording time when an alarm is triggered.
Alarm Out: Check the box to enable the alarm output.
Show Message: Check the box to enable the function. When an alarm is triggered, an alarm
message will be displayed on the live screen.
Send Email: Check the box to enable the function. When alarm is triggered, the DVR will
send an email alert to the receiver. Note that for this function to work, you have to set up
the Email function in advance (refer to 4.1.1.3.2 Email).
Full Screen: Check the box to enable the function. When alarm is triggered, the
corresponding channel with the alarm will be switched to full screen on the live screen.
Record Channel: Check the box to enable the alarm event recording function. When an
alarm event occurs, the selected channel(s) will be recorded. Note that the IP Channels will
only appear when HVR hybrid mode is selected (Main Menu < System < General).
Copy: You can apply the same configurations from one channel to the desired channels.
Select a channel from the Copy drop-down list first and then select a desired channel (or All)
from the To drop-down list, click the Copy button, the selected channel(s) will be applied
with the same configurations.
Click Default to return to factory default value, Save to save the settings, or Cancel to cancel
and leave the page.
54