Basic Connection - EverFocus VANGUARD 16x8 User Manual

2.2 Basic Connection

The instructions below describe the basic connection to the DVR.
The image below uses VANGUARD 8x4 as example.
3.5" HDD
1
Line Level Audio Out
1. To record videos, install 3.5" HDD(s) to the DVR. Please refer to 2.1 Hard Disk Installation.
2. To connect to the TVI/AHD/SD cameras, connect the cameras to the BNC ports.
3. Connect microphones to the audio input ports to transmit audio from the camera to the DVR.
Note that the microphones with a (built-in) amplifier and external power supply are required.
4. To view videos at local site, connect a monitor to the HDMI or VGA port using the HDMI or
VGA cable supplied by the monitor manufacturer.
5. To listen to the audio from device side, connect speakers to the audio output. Note that the
speakers with a (built-in) amplifier and external power supply are required.
6. Use a standard RJ-45 CAT5 Ethernet cable to connect the DVR to the network and then
optionally connect IP cameras to the DVR.
7. Optionally connect a mouse to the DVR to control the system. You can also control the
system using the supplied IR Remote Control (Appendix A. IR Remote Control).
8. Use the supplied Power Cord and Adaptor to connect the DVR to the power outlet.
VANGUARD 16x8 / VANGUARD 8x4 / VANGUARD 4x2
TVI/AHD/SD Camera
2
5
Web Remote Client
Line Level Audio Input
3 4
IP Cameras
VANGUARD CMS
9
Monitor (HDMI / VGA)
6 7 8
Network Power Supply
Mouse