Ptz - EverFocus VANGUARD 16x8 User Manual

VANGUARD 16x8 / VANGUARD 8x4 / VANGUARD 4x2

5.4.6.2 PTZ

You can configure the PTZ settings on this page.
Channel: Select the channel connected with PTZ camera.
Protocol: Select PTZ protocol, choose from the following protocols. (Note: All cameras on the RS-
485 bus must use the same protocol). If you want to use the UTC function, select UTC1 (eZ.HD
Camera) or UTC2 (EverFocus PTZ camera). For more details on UTC function, please refer to
1.6 eZ. Controller Function Description.
Baudrate: This field is to set the speed at which is used to transmit instruction or information
through the RS-485 port on the DVR.
Data Bit: This field is the data bit at which you will be transferring.
Stop Bit: This field is to set the stop bit for the RS-232 connection.
Parity: This field is to select the parity level at which you will be connected.
Tour: Switch to the right to enable the Tour function.
Address: Input the ID address of the PTZ camera. Note this address should match the one set up
on the PTZ camera.
Click Save to save the settings or Refresh to refresh the page.
Click Copy to apply the same configurations from the current channel to the desired
channels. Select the desired channel(s) and then click the Copy button, the selected
channel(s) will be applied with the same configurations.
130