Ptz - EverFocus VANGUARD 16x8 User Manual

VANGUARD 16x8 / VANGUARD 8x4 / VANGUARD 4x2

4.1.3.2 PTZ

You can configure the PTZ and Keyboard settings on this page.
Channel: Select the channel connected with PTZ camera.
Signal Type: Select Analog for the connected PTZ camera. This feature will only appear when
HVR hybrid mode is selected (Main Menu < System < General).
Protocol: Select PTZ protocol, choose from the following protocols. (Note: All cameras on the RS-
485 bus must use the same protocol). If you want to use the UTC function, select UTC1 (eZ.HD
Camera) or UTC2 (EverFocus PTZ camera). For more details on UTC function, please refer to
1.6 eZ. Controller Function Description.
Baudrate: This field is to set the speed at which is used to transmit instruction or information
through the RS-485 port on the DVR.
Data Bit: This field is the data bit at which you will be transferring.
Stop Bit: This field is to set the stop bit for the RS-232 connection.
Parity: This field is to select the parity level at which you will be connected.
Tour: Select Enable to enable the tour function.
Address: Input the ID address of the PTZ camera. Note this address should match the one set up
on the PTZ camera.
Copy: You can apply the same configurations from one channel to the desired channels.
Select a channel from the Copy drop-down list first and then select a desired channel (or All)
from the To drop-down list, click the Copy button, the selected channel(s) will be applied
with the same configurations.
Click Default to return to factory default value, Save to save the settings, or Cancel to cancel
and leave the page.
72