Alarm - EverFocus VANGUARD 16x8 User Manual

VANGUARD 16x8 / VANGUARD 8x4 / VANGUARD 4x2

5.4.5.2 Alarm

You can configure the Alarm setting on this page.
Alarm In: Select an alarm input from the drop-down list.
Alarm Type: Select an alarm type. Normally-Open or Normally-Close. If you want to disable
the alarm, select Off.
Buzzer: Set up the time for buzzer to sound when an alarm is triggered.
Alarm Output: Set up an alarm output time (duration) when an alarm is triggered.
Show Message: Switch to the right to enable the function. When an alarm is triggered, an
alarm message will be displayed on the live screen.
Send Email: Switch to the right to enable the function. When alarm is triggered, the DVR will
send an email alert to the receiver. Note that for this function to work, you have to set up
the Email function in advance (refer to 5.4.4.2 Email).
Full Screen: Switch to the right to enable the function. When alarm is triggered, the
corresponding channel with the alarm will be switched to full screen on the live screen.
Alarm Out: Switch to the right to enable the alarm output.
Post Recording: Select a post recording time when alarm events occur.
Recording Channel: Check the All checkbox to select all channels. When an alarm event
occurs, the selected channel(s) will be recorded.
Analog/IP Channels: Check the checkbox to select all channels or check the desired channel
checkboxes. When a motion event occurs, the selected channel(s) will be recorded.
Click Save to save the settings or Refresh to refresh the page.
127