Time Offset: Select an offset time.
Start Time: Select a start time for the DST to start.
End Time: Select an end time for the DST to stop.
NTP: Select to configure the NTP function.
Enable NTP: Switch to the right to enable the NTP function. When NTP function is
enabled, the system will calibrate the system time at 00:07:50 daily and every time
when the system is started up.
Server Address: Select a NTP server.
Time Zone: Select a time zone.
Click Save to save the settings or Refresh to refresh the page.
VANGUARD 16x8 / VANGUARD 8x4 / VANGUARD 4x2
133