Terminal Cover; Terminal Cover; Cimr-T 2A0004 To 0081, 4A0002 To 0044 - YASKAWA T1000A Technical Manual

3.5 Terminal Cover

3.5

Terminal Cover

Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
u CIMR-T 2A0004 to 0081, 4A0002 to 0044
n
Removing the Terminal Cover
1.
Loosen the terminal cover screw.
Figure 3.7
2.
Push in on the hook located on the bottom of the terminal cover, and gently pull forward. This should remove the
terminal cover.
Figure 3.8
n
Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided.
page 59 and Wiring the Control Circuit Terminal on page 62
After all wiring to the drive and other devices is complete, reattach the terminal cover.
Figure 3.9
50
Figure 3.3 Removing the Terminal Cover
Figure 3.4 Removing the Terminal Cover
for details on wiring.
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
Power lines and signal wiring
exit through the opening provided.
Figure 3.5 Reattaching the Terminal Cover
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual
Refer to Wiring the Main Circuit Terminal on