YASKAWA T1000A Technical Manual page 392

B.3 Parameter Table
n
H2: Multi-Function Digital Outputs
No.(Addr.) Name
H2-01 Terminal M1-M2 function
(40BH) selection (relay)
H2-02 Terminal M3-M4 function
(40CH) selection (relay)
H2-03 Terminal M5-M6 function
(40DH) selection (relay)
H2-06
Watt Hour Output Unit Selection
(437H)
H2-
Function
Setting
0 During fun
1 Zero Speed
2 Speed agree 1
3 User-set speed agree 1
4 Frequency detection 1
5 Frequency detection 2
6 Drive ready
7 DC bus undervoltage
8 During baseblock (N.O.)
9 Frequency reference source
A Run command source
B Torque detection 1 (N.O.)
C Frequency reference loss
D Braking resistor fault
E Fault
F Through mode
10 Minor fault
392
All Modes
Refer to H2 Multi-Function Digital Output Settings on page 392
values.
All Modes
Outputs a 200 ms pulse signal when the watt-hour counter increases by the units selected.
0: 0.1 kWh units
1: 1 kWh units
2: 10 kWh units
3: 100 kWh units
4: 1000 kWh units
H2 Multi-Function Digital Output Settings
All Modes
Closed: A Run command is active or voltage is output.
All Modes
Open: Output frequency is above the minimum output frequency set in E1-09.
Closed: Output frequency is below the minimum output frequency set in E1-09.
All Modes
Closed: Output frequency equals the speed reference (plus or minus the hysteresis set to L4-02).
All Modes
Closed: Output frequency and speed reference equal L4-01 (plus or minus the hysteresis set to L4-02).
All Modes
Closed: Output frequency is less than or equal to the value in L4-01 with hysteresis determined by L4-02.
All Modes
Closed: Output frequency is greater than or equal to the value in L4-01 with hysteresis determined by L4-02.
All Modes
Closed: Power up is complete and the drive is ready to accept a Run command.
All Modes
Closed: DC bus voltage is below the Uv trip level set in L2-05.
All Modes
Closed: Drive has entered the baseblock state (no output voltage).
All Modes
Open: External Reference 1 or 2 supplies the frequency reference (set in b1-01 or b1-15).
Closed: Digital operator supplies the frequency reference.
All Modes
Open: External Reference 1 or 2 supplies the Run command (set in b1-02 or b1-16).
Closed: Digital operator supplies the Run command.
All Modes
Closed: An overtorque or undertorque situation has been detected.
All Modes
Closed: Analog frequency reference has been lost.
All Modes
Closed: Braking resistor or transistor is overheated or faulted out.
All Modes
Closed: Fault occurred.
All Modes
Set this value when using the terminal in the pass-through mode.
All Modes
Closed: An alarm has been triggered, or the IGBTs have reached 90% of their expected life span.
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual
Description
for a description of setting
Description
Setting Page
Default: 0
Min: 0 190
Max: 161
Default: 1
Min: 0 190
Max: 161
Default: 2
Min: 0 190
Max: 161
Default: 0
Min: 0 200
Max: 4
Page
191
191
191
192
192
193
193
193
193
194
194
194
194
194
194
194
194