YASKAWA T1000A Technical Manual page 332

7.5 Drive Replacement
The following procedure explains how to replace a drive. This section provides instructions for drive replacement only.
To install option boards or other types of options, then refer to the specific manuals for those options.
NOTICE: When transferring a braking transistor, braking resistor, or other type of option from a damaged drive to a new replacement
drive, make sure they are working properly before reconnecting them to the new drive. Replace broken options to prevent immediate
break down of the replacement drive.
1.
Remove the terminal cover.
Figure 7.28
2.
Loosen the screws holding the terminal board in place. Take out the screw securing the bottom cover and
remove the bottom cover from the drive.
Note: Drives set up for compliance with IP00 do not have a bottom cover.
Figure 7.29
3.
Slide the terminal board as illustrated by the arrows, and remove it from the drive along with the bottom cover.
Figure 7.30
Figure 7.31
332
Figure 7.27 Drive Replacement: Removing the Terminal Cover
Figure 7.28 Drive Replacement: Removing the Terminal Board
Figure 7.29 Drive Replacement: Remove the Terminal Board
Figure 7.30 Drive Replacement:
Removable Terminal Board Disconnected from the Drive
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual
YEG
YEG
YEG
YEG