Additional Wan-Related Configuration Tasks; Verify The Connection; What To Do Next - NETGEAR ProSafe FVS318N Reference Manual

Additional WAN-Related Configuration Tasks

If you want the ability to manage the wireless VPN firewall remotely, enable remote
management (see
remote management, NETGEAR strongly recommends that you change your password (see
Change Passwords and Administrator and Guest Settings
You can set up the traffic meter for the WAN interface, if you wish. See
Traffic Meter on page 346.

Verify the Connection

Test the wireless VPN firewall before deploying it in a live production environment. Verify that
network traffic can pass through the wireless VPN firewall:
• Ping an Internet URL.
• Ping the IP address of a device on either side of the wireless VPN firewall.

What to Do Next

You have completed setting up the WAN connection for the wireless VPN firewall. The
following chapters and sections describe important tasks that you need to address before
you deploy the wireless VPN firewall in your network:
• Chapter 3, LAN Configuration
• Chapter 4, Wireless Configuration and Security
• Configure Authentication Domains, Groups, and Users
• Manage Digital Certificates for VPN Connections
• Use the IPSec VPN Wizard for Client and Gateway Configurations
• Chapter 7, Virtual Private Networking Using SSL Connections
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Configure Remote Management Access
IPv4 and IPv6 Internet and Broadband Settings
on page 331). If you enable
on page 329).
on page 296
on page 313
53
Enable the WAN
on page 194