Configure The L2Tp Server - NETGEAR ProSafe FVS318N Reference Manual


To enable NetBIOS bridging on a configured VPN tunnel:
1. Select VPN > IPSec VPN > VPN Policies. The VPN Policies screen displays (see
Figure 141 on page 231).
2. Specify the IP version for which you want to edit a VPN policy:
• IPv4. In the upper right of the screen, the IPv4 radio button is already selected by
default. Go to
• IPv6. Select the IPv6 radio button. The VPN Policies screen for IPv6 displays.
3. In the List of VPN Policies table, click the Edit table button to the right of the VPN policy that
you want to edit. The Edit VPN Policy screen displays. (The following figure shows only the
top part with the General section of the Edit VPN Policy screen for IPv6.)
Figure 159.
4. Select the Enable NetBIOS? check box.
5. Click Apply to save your settings.

Configure the L2TP Server

As an alternate solution to IPSec VPN tunnels, you can configure a Layer 2 Tunneling
Protocol (L2TP) server on the wireless VPN firewall to allow users to access L2TP clients
over L2TP tunnels. A maximum of 25 simultaneous L2TP user sessions are supported. (The
very first IP address of the L2TP address pool is used for distribution to the wireless VPN
firewall.)
An L2TP Access Concentrator (LAC) typically initiates a tunnel to fulfill a connection request
from an L2TP user; the L2TP server accommodates the tunnel request. After an L2TP tunnel
Virtual Private Networking Using IPSec and L2TP Connections
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Step 3.
263