Introduction; Purpose Of The Manual; Additional Resources; Document And Software Version - Danfoss VLT FC 102 Installation Manual

Introduction

1 1
1 Introduction

1.1 Purpose of the Manual

This manual provides requirements for mechanical and
electrical installation of the VLT
basic kit. Separate installation instructions for optional
components - bus bars and back-channel cooling - are
provided with those kits.
This guide includes information on:
•
Wiring of mains and motor connections.
•
Wiring of control and serial communications.
•
Control terminal functions.
•
Detailed tests that must be performed before
start-up.
•
Initial programming to verify proper functioning
of the drive system.
The installation guide is intended for use by qualified
personnel.
To install the drive modules and paralleling kit safely and
professionally, read and follow the installation guide. Pay
particular attention to the safety instructions and general
warnings. Always keep this installation guide with the
panel containing the VLT
components.
®
VLT is a registered trademark.

1.2 Additional Resources

Other resources are available to understand functions and
programming of the VLT
•
The VLT
contains detailed information about the
capabilities and functionality of motor control
systems using these drive modules, and provides
guidance for designing this type of system.
•
The VLT
contains detailed procedures for start-up, basic
operational programming, and functional testing.
Additional information describes the user
interface, application examples, troubleshooting,
and specifications.
•
Refer to the Programming Guide applicable to the
particular series of VLT
used in creating the drive system. The
programming guide describes in greater detail
how to work with parameters and provides
application examples.
4
VLT
®
Parallel Drive Modules
®
Parallel Drive Modules
®
Parallel Drive Modules.
®
Parallel Drive Modules Design Guide
®
Parallel Drive Modules User Guide
®
Parallel Drive Modules
Danfoss A/S © 08/2017 All rights reserved.
®
Parallel Drive Modules
•
The VLT
contains detailed service information, including
information applicable to the VLT
Modules.
•
The VLT
lation Instructions contain detailed information
about installing the DC fuses.
•
The VLT
lation Instructions contain detailed information
about installing the bus bar kit.
•
The VLT
lation Instructions contain detailed information
about installing the duct kit.
Refer to other supplemental publications and manuals,
available from Danfoss. See drives.danfoss.com/knowledge-
center/technical-documentation/ for listings.

1.3 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
Edition
MG37K3xx
Table 1.1 Document and Software Version

1.4 Approvals and Certifications

Table 1.2 Approvals and Certifications

1.5 Disposal

®
FC Series, D-frame Service Manual
®
Parallel Drive
®
Parallel Drive Modules DC Fuses Instal-
®
Parallel Drive Modules Bus Bar Kit Instal-
®
Parallel Drive Modules Duct Kit Instal-
Remarks
Added 230 V external FC 102 (5.0x),
power supply content FC 202 (3.0x),
FC 302 (7.6x)
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
Software
version
MG37K302