Appendix; Disclaimer - Danfoss VLT FC 102 Installation Manual

Appendix

8 Appendix

8.1 Disclaimer

Danfoss shall have no obligation with respect to any
product that
•
is not installed according to the standard configu-
ration as specified in the installation guide.
•
is improperly repaired or altered.
•
is subjected to misuse, negligence, and improper
installation where the guidelines were not
followed.
•
is used in a contradictory manner to the
instructions provided.
•
is a result of normal wear and tear.
8.2 Symbols, Abbreviations, and
Conventions
°C
Degrees Celsius
°F
Degrees Fahrenheit
AC Alternating current
AWG American wire gauge
DC Direct current
EMC Electro magnetic compatibility
ETR Electronic thermal relay
FC Frequency converter
IP Ingress protection
LCP Local control panel
MCT Motion control tool
MDCI
Multi-drive control interface
C
PCB Printed circuit board
PELV Protective extra low voltage
PM
Permanent magnet motor
Motor
RCD Residual current-operated protective device
Regen Regenerative terminals
RFI Radio frequency interference
RPM Revolutions per minute
Table 8.1 Symbols and Abbreviations
MG37K302
Installation Guide
Conventions
Numbered lists indicate procedures.
Bullet lists indicate other information and description of
illustrations.
Italicized text indicates:
•
•
•
All measurements are given in both metric units and
imperial units. Imperial units are in ( ).
Danfoss A/S © 08/2017 All rights reserved.
Cross-references.
Links.
Parameter names.
8 8
67