Memory Card - Kollmorgen S700 Instruction Manual

Kollmorgen
7.19

Memory card

Always switch off the S700 before inserting or removing the memory card. If an absolute
encoder is used, homing must be carried out before the parameters are loaded into a
new device.
To download new firmware to an amplifier without a PC connection, proceed as follows:
1.
2.
3.
4.
5.
The parameter file can also be loaded automatically on a restart. If a parameter file with
the name "default.par" has already been saved on the memory card, it will be loaded by
the firmware at this point. This allows automatic updating of firmware and parameters.
S701x2-S724x2 Instructions Manual
In the top of the servo amplifier there is a card reader for
memory cards. The firmware and a full set of parameters
(with control buttons and setup software) can be stored on
the memory card and reloaded onto the servo amplifier.
MMC and SD cards are supported. This function means that
a replacement device or identical shafts in standard produc-
tion machines can be set up very quickly and easily.
Uploads and Downloads from and to the memory card can
be started with the keypad or with the setup software using.
Operating with ASCII commands is described in the Pro-
duct-WIKI on page
Save the firmware to be programmed onto a memory card under the name
"default.s19" (S-record format) or "default.bin" (binary format).
Disconnect the power to the amplifier (24 V supply OFF) and insert the card in the
memory card slot on the amplifier.
Press and hold down both operating keys (
supply voltage to the amplifier. "—" appears in the display to indicate that the
monitor program has been activated. In case of access problems the drive display
shows the letters "CCC". The interrupted command proceeds after re-insertion of
the memory card.
Press both operating keys again to start the update process. The progress of
the update can be monitored in the display:
- First, the firmware is downloaded from the card to the internal memory.
- During this phase, the display counts from 0 to 100.
- Next, the internal firmware memory is deleted. During this phase, 100 is
displayed permanently.
- Once the firmware memory has been deleted, the firmware is written. This phase
is indicated in the display by the display counting backwards from 100 to 0.
Once programming has been completed, the firmware is started automatically.
07/2014
"Memory
Electrical installation
Card".
) and switch on the 24 V
105