Expansion Card -Synqnet - Kollmorgen S700 Instruction Manual

Kollmorgen
9.1.6

Expansion card -SYNQNET-

This section describes the SynqNet expansion card for S700. Information on the range of
functions and the software protocol can be found in the SynqNet documentation.
9.1.6.1 NODE ID Switch
With these hexadecimal switches you can set the main and low significant bytes of the
Node ID separately. SynqNet does not require an address for correct operation in the net-
work, however in some machines this can be a convenient way of identifying build options
to the application program.
9.1.6.2 Node LED table
LED#
LED1, green
LED2, yellow
LED3, green
LED4, yellow
9.1.6.3 SynqNet Connection, Connector X21B/X21C (RJ-45)
Connection to the SynqNet network via RJ-45 connectors (IN and OUT ports) with inte-
grated LEDs.
S701x2-S724x2 Instructions Manual
07/2014
Name Function
ON = receive valid (IN port)
LINK_IN
OFF= not valid, power off, or reset.
ON = network cyclic
CYCLIC BLINK = network not cyclic
OFF = power off, or reset
ON = receive valid (OUT port)
LINK_OUT
OFF = not valid, power off, or reset
ON = repeater on, network cyclic
REPEATER BLINK = repeater on, network not cyclic
OFF = repeater off, power off, or reset
Expansions
LED2 LED1 LED4 LED3
135