Utilities by Serial Command
Table 11-1 Summary of Utility Serial Commands
Command Type
Command
Read Rate
<Cp>
<C>
<Cm>
<Cs>
<a1>
<Ce>
<J>
Counters
<T>
<U>
<V>
<W>
<N>
<O>
<X>
<Y>
Device Control
<L1>
<L2>
<L3>
<I>
<H>
<KF>
<KE>
Master Database
<#>
<E>
<F>
<)data)>
<Mmaster symbol
number,data>
<M#?>
<M?>
<)>
<))>
<Mmaster symbol
number,>
Firmware
<!>
<!b>
<!a>
<#>
<#b>
<#a>
MS-820 Industrial Bar Code Scanner User's Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 11 Utilities
Name
Enter Single Symbol Percent Rate Test
Enter Single Symbol Decode Rate Test
Enter Multisymbol Percentage Rate Test
Enter Multisymbol Decode Rate Test
PDF Information
Extended Read Rate
Exit Decode Rate and Percent Rate Test
Trigger Counter
Trigger Counter Reset
Good Read/Match Counter
Good Read/Match Counter Reset
Noread Counter
Noread Counter Reset
Mismatch Counter
Mismatch Counter Reset
Output #1 Pulse
Output #2 Pulse
Output #3 Pulse
Disable Scanner
Enable Scanner
Send Motor Off
Send Motor On
Master Symbol Database Size
Enable Master Symbol
Disable Master Symbol
Enter symbol data as master symbol.
Enter Data to Database for Specified Symbol.
Note:
<K231,#,data>
does the same.
Request Master Symbol Data For Specific Symbol
Note:
<K231,#,?>
does the same.
Request all Master Symbol Information
Note:
<K231,?>
does the same.
Request Information for Master Symbol #1
Delete Master Symbol #1
Delete Master Symbol
Note:
<K231,#,>
does the same.
Display Checksums of EPROM
Display Checksum for Boot Code
Display Checksum for Application Code
Display Part Number
Display Boot Code Part Number
Display Application Code Part Number
11-3
Need help?
Do you have a question about the MS-820 and is the answer not in the manual?