page 112
For DSA1 with DS3222-3228: Copying the DCM.ini file
VII
In order that all available syringes can be controlled with the DSA1 software, an
initialisation file matching the dosing unit must be copied into the installation
folder of the DSA1 software.
1. Insert the DSA1 CD.
2. Open the folder ini-files.
SPA C SPA C SPAC SPAC
3. Open the folder for your multi-dosing unit (DS3222-DS3228).
SPA C SPA C SPAC SPAC
4. Copy the file
5. Open the installation folder of the DSA1 software.
6. Paste the previously copied
that the existing file is to be overwritten.
SPA C SPA C SPAC SPAC
Warranty and caveat emptor
VIII
The warranty terms and deadlines are described in the general terms and
conditions of KRÜSS GmbH.
There is no warranty claim if the product was damaged due to careless usage or
improper treatment or if it was not used according to purpose, and if the
instructions and danger warnings in the manual were not observed.
The warranty claim is void if changes on the product are performed by the
customer or a third party without prior consultation of KRÜSS GmbH, which go
beyond the activities described in the manual. This also applies to repair work,
which was independently performed or carried out by a third party.
SPA C SPA C SPAC SPAC
Copyright and right to make alterations
IX
The information contained in this document may be altered without notice and
does not represent any obligation by KRÜSS GmbH.
Neither this manual nor any part of it may be reproduced or transmitted for any
purpose whatsoever in any form and by any means, electronic or mechanical, by
photocopy or drawing without the express approval of KRÜSS GmbH in writing.
2004-2014, KRÜSS GmbH, Hamburg, all rights reserved.
SPA C SPA C SPAC SPAC
DCM.ini
into the Windows clipboard.
DCM.ini
file into the installation folder. Confirm
Appendix