Mounting A Spacer; Threads For Mounting Spacers And Axes; Replacing An Axis With A Spacer - kruss DSA100 Installation And Operation Manual

page 32
7.2

Mounting a spacer


When the DSA100 is delivered the required spacers are usually already
mounted.
7.2.1

Threads for mounting spacers and axes

Each of the spacers has three threaded holes for screwing onto a different spacer
(S) and four threaded holes at the corners for screwing an axis (A) onto the spacer:
Mount the spacer on top of the already mounted spacer using the three

hexagon socket screws provided.

In rare cases the spacer must be mounted on the base plate of the DSA100.
7.2.2

Replacing an axis with a spacer

If an axis must be removed or replaced by a spacer, proceed as follows:
1. Move the installed x or y axis out of the center to that the fixing screws are
released.
With software-controlled axes: please consult the software manual to see

how the axes are moved.
2. Remove all available cable connections from the axes.
Mounting axes