Power Supply / Power Switch; Connecting The Computer; Carrying Out The Connection - kruss DSA100 Installation And Operation Manual

Setting up
5.5

Power supply / power switch

A net adapter was delivered with the DSA100.
 Connect the round 4-pin plug to the 24V DC socket on the rear panel of the
DSA100.
 Connect the net adapter to the mains (100-240V AC).

The main switch Power is on the right hand side (rear view). After the instrument
has been switched on all the software-controlled axes, the needle selector and
the syringe drives (if present) move to their zero positions for initialisation.

When the instrument is switched on the LED on the front panel lights up to
show an intensive blue; when the instrument is switched off it is still weakly lit
up.
SPA C SPA C SPAC SPAC
5.6

Connecting the computer

The computer is to be connected to the RS232 connection (Serial PC ) at the rear
side of the DSA100.
A corresponding cable is within the supply of the instrument.
5.6.1

Carrying out the connection

Serial port connection
Connect the RS232 connector (Serial PC ) at the DSA100 rear panel with a serial

interface of the computer.
page 23