Port Assignment - kruss DSA100 Installation And Operation Manual

page 24
USB port connection / USB driver installation

Two driver components must be installed, so that the installation routine of the
hardware assistant must be carried out twice.
1. Insert the DSA4 CD-ROM.
2. Plug the adapter KA10 into a USB port of the computer. Connect the RS232
connection (Serial PC ) at the rear of the DSA100 to the adapter. Switch on the
DSA100.
!
Afterwards, always use the same USB port of the computer if possible.
Otherwise the serial port assignment ( Chapter 5.6.2) must be changed.
3. Select manual for the driver search when carrying out the driver installation.
4. Select the folder
5. Click on OK. Driver installation starts.
5.6.2

Port assignment

After the start of the software the port to which the DSA100 is connected must be
entered.
Assignment in DSA1
Select the menu

SUPPORT KA10
 
Options Device Control

Driver Windows 7.0
Options.
Setting up
on the DSA4 CD.