Weight And Dimensions (Not Mounted); Mounting The Tilting Table - kruss DSA100 Installation And Operation Manual

Mounting axes
CAUTION
Damage by projecting y-axis
The long y-axis (range of movement 350 mm) could be damaged during the tilting
process.
 Before the tilting movement move the axis so that it does not project from the
side moving downward.
Carefully check the maximum possible axis tilt angle at the required axis setting

by increasing the tilt angle step by step; do not exceed this maximum angle.
!
Do not operate the tilting table in case of an installed high-temperature dosing
system DS3241.
7.6.2

Weight and dimensions (not mounted)

Weight
Dimensions (W × D × H)
7.6.3

Mounting the tilting table


Assembling a tilting table should be carried out with three persons.
1. Turn the DSA100 aside. Four threaded holes are driven into the bottom.
2. Unscrew the four feet of the DSA100.
3. Put the DSA100 onto the tilting table so that the rear panel connections of the
DSA100 and the tilting table lie on the same side.
33.1 Kg
1190 × 400 × 550 mm
page 45