Computer System; Mounting An Ieee-1394 Interface Board - kruss DSA100 Installation And Operation Manual

Computer system

4 Computer system
If you have purchased your computer from KRÜSS together with the DSA100 and if
the frame grabber board or IEEE-1394 interface board has already been installed
then you can skip this chapter.
For system requirements for the computer please read appendix I.

SPA C SPA C SPAC SPAC
4.1

Mounting an IEEE-1394 interface board

DANGER
Electric shock by charged components
Touching charged components can lead to an electric shock with fatal
consequences.
 Switch off the computer and pull out the mains plug before opening the
computer housing.
!
Touching the expansion board when the body is charged electrostatically can
damage electronic components.
Before touching the board discharge yourself, for example by touching a

metallic part of the panel.
!
Mounting the board must be carried out before driver installation and before
installing the DSA software.
!
If necessary, obtain the help of a computer specialist.
1. Switch off the computer and pull out the mains plug. Open the computer
housing.
2. Remove the board from the packaging and insert it in a free PCI Express slot.
3. Fix the bracket of the board to the housing. Use the substitute bracket delivered
with the board for a low profile case.
4. Close the computer housing, reconnect your PC and switch it on.
SPAC SPAC SPAC SPA C
page 11