Set The Separator Gap - Pitney Bowes W660 Operator's Manual

3 • W660/W680 Basics
Setting Up A
Job (continued)
3-6
for detailed instructions. If you have the W660/W680 print driver
loaded on your computer, you can easily perform these functions
from within your application.
10. OutputStacker Tray
Printed material is deposited in the stacker (catch) tray. The tray
holds about 5" of material.
11. Output Area
Where printed material is ejected from the printer.
12. Exit Rollers (Not Shown)
Guides the printed material as it exits the printer. Adjust so that
each roller overlaps the edge of the material by 1/4".
13. Transport Door
Open to gain access to the print cartridge and exit rollers.
The following procedure describes the steps for setting up a
job.

1. Set the Separator Gap

Switching from one material type to another requires setting the
gap between the separators and the feed roller before printing
begins. To find the correct spacing, refer to the figure on the next
page and follow the instructions below:
1. Loosen the lock knobs to unlock all three H-Blocks.
2. Lift all three H-Blocks to their highest position and lock
in place.
3. Place a sample piece of material into the input area.
Align the sample with the left wall of the input area, then
place it between the separator fingers (the lower section
of the H-Blocks) and the feed roller.
4. Lower only the H-Blocks that come in direct contact with
the sample material. Make sure the material is between
the separator fingers and the feed rollers, and that the
separator fingers do not directly contact the feed rollers.
Pitney Bowes W660/W680 Operator Guide