Using The Terminal Properties Dialog Box - Wyse 3315SE Reference Manual

72
Terminal Management

Using the Terminal Properties Dialog Box

Invoke this dialog box by pressing the F2 key from the Winterm Connection
Manager.
The Terminal Properties dialog box consists of a total of ten properties sheets that
can be invoked by clicking on their individual tabs. The following seven sheets can
be used to change terminal properties:
• Input - discussed in "Input Configuration."
• Display - discussed in "Display Configuration."
Network - discussed in "Network Configuration."
•
• Upgrade - discussed in "FTP Pull Firmware Upgrades."
• Security - discussed in "Security Properties."
• Apps - discussed in "Additional Applications."
• Devices - discussed in "Dial-Up Connections."
These properties sheets are discussed in detail in the following chapters of this
guide. The General, SysInfo, and About properties sheets are discussed in
"General Terminal Information."
When terminal properties have been changed, the Terminal Settings Change
dialog box is used to restart the terminal. See "Shutting Down the Terminal" for
more information about this dialog box.
Note
The amount of RAM that is available depends on the
model of terminal in use.