Table of Contents
Advertisement
34
Installation Procedures
Cable Retaining Clip and Shroud Installation
The plastic shroud may be installed to conceal the cable connectors at the rear of
the terminal housing. A retaining loop is included to keep the cables together.
Proceed as follows.
1. Attach the upper and lower shroud mounting clips as shown in figure 6-5, using
the existing screws.
2. Attach the cables to their respective connectors on the back panel of the
terminal (see "Connecting the Terminal").
3. Gather the cables together and place the retaining loop over them. Insert the
ends of the retaining loop into the catches on the lower shroud mounting clip
(see the following figure).
Figure 6-4 3315SE/3320SE Cable Retaining Clip Installation
4. Gently pull the lower ends of the shroud apart and place it over the cables.
5. Place the slots in the lower end (split end) of the shroud under the lower shroud
mounting clip, as shown in the following figure.
6. Rotate the upper end of the shroud until the top slot goes over and engages the
upper mounting clip, as shown in the following figure.
Retainer Catches
Cable Retaining
Loop
Advertisement
Table of Contents
Troubleshooting
