Using The Connections Properties Sheet - Wyse 3315SE Reference Manual

84
Terminal Management

Using the Connections Properties Sheet

The functions of the Connections properties sheet are used to make (launch)
terminal connections. Figure 16-1 shows the Connections properties sheet, the
default of the Winterm Connection Manager dialog box.
After a connection is created, it will show in the Connection Name list. The
connection's name will be listed under Connection Name and the type of
connection will be listed under Type. See "Creating New Connections" for further
information.
The Connections properties sheet contains four functions. The following table
identifies and describes each of them.
Table 16-1 Connections Properties Sheet
Function
Connection Name
Connect
End
Shut Down
Description
This box lists the connections that you have created.
See "Using the Configure Properties Sheet" for
information about creating connections. Default RDP
Connection is the default.
Click on the Connect command button to make the
highlighted connection. Click on a connection in the
Connection Name list box to highlight it. You can also
double-click on a selection to make a connection.
Click on the End command button to end the
connection process. When you press the End button
and the connection is active, the End Task dialog
displays. This command button is enabled when a
session is active.
Click on the Shut Down command button to:
• Log off of the terminal
• Shut down the terminal
• Shut down and restart the terminal
See "Shutting Down the Terminal" for more
information.