3515Se/3715Se Osd (On-Screen Display) Menu; 3515Se/3715Se/3720Se Terminal Front Panel - Wyse 3315SE Reference Manual

Instructions for using the terminal's front panel are listed in the following table.
Table 8-2 3515SE/3715SE/3720SE Terminal Front Panel
Button
MENU (OSD)
SELECT (Brightness)
ADJUST (Contrast)
Figure 8-3 3515SE/3715SE OSD (On-Screen Display) Menu
H-CENTER
H-SIZE
V-CENTER
V-SIZE
PIN
Function
To use:
1. Press the MENU button to invoke the OSD (refer to
the following figure).
2. Press the plus [+] or minus [-] SELECT buttons to
select the adjustment you want to make (see the
following table, OSD Alignment, for settings).
3. Press the ADJUST plus [+] or minus [-] buttons to
make your adjustment.
4. Press MENU to save your adjustments and close
the OSD.
Note
The OSD can be invoked at any time the
terminal is on, even while running an
application. It automatically closes after a period
of inactivity (2 minutes). If this happens before
you complete your adjustments, press the
MENU button to invoke the OSD again.
Press the plus [+] and minus [-] buttons on the
terminal's front panel to increase or decrease the
display's brightness.
Press the plus [+] and minus [-] buttons on the
terminal's front panel to increase or decrease the
display's contrast.
TRAPEZOID
ROTATE
RECALL MODE
+ +
49