Wyse 3315SE Reference Manual page 110

86
Terminal Management
After a connection is added or edited, it will appear in the Connection Name list.
The connection's name will be listed under Connection Name, and the type of
connection will be listed under Type. Also, if the connection is designated as the
start-up connection, a Yes will display in Startup. The remainder of this section
discusses adding connections. See "Editing Connections" and "Using the Startup
Function" for further information.
The Configure properties sheet contains five basic functions. The following table
identifies and describes each of them.
Table 16-2 Configure Properties Sheet
Function
Add
Edit
Delete
Startup...
Connection Name
Note
A connection name must be selected for the Edit,
Delete, and Startup functions to be enabled.
Description
The Add button allows the user to create a new
connection. When this button is pressed, the New
Connection dialog box displays. See "Creating New
Connections" for further information about adding new
connections to the Connection Name list. See
"Multiple Sessions" for running more than one session
at a time.
The Edit command button allows the user to edit or
modify the properties of an existing connection. When
this button is pressed, the Properties dialog box
displays. See "Editing Connections" for more
information about editing connections.
The Delete button lets you delete a connection. When
you click this command button, the Confirm
Connection Delete dialog box displays. Click on Yes
to complete the deletion. Click on No to cancel the
deletion.
The Startup button allows the user to specify the
startup behavior of a connection. See "Using the
Startup Function" for more information.
The Connection Name list box allows the user to view
and select connections for the purposes of adding,
editing, and deleting connections, or for specifying the
startup behavior of a connection.