Table of Contents
Advertisement
6
Models 3315SE/3320SE Terminal
Installation
This section discusses the procedures for installing the standard modular
terminals. The terminals can be freestanding or, optionally, mounted on a wall. The
following paragraphs describe how to connect and set up the terminals in both
configurations.
Locating the Terminal
Position the terminal on a clean, horizontal surface that is free from vibration and
out of direct sunlight. Refer to "Terminal Specifications" for environmental
specifications.
Connecting the Terminal
Make all connections to the back panel before connecting the terminal to power. A
shroud and cable retaining loop (described in "Shroud and Cable Retaining Loop
Attachment") can be installed after the cables are connected and the terminal is
mounted in place. The following figure shows a terminal's back panel connectors.
Advertisement
Table of Contents
Troubleshooting
