Initial Terminal Setup; Using The Setup Wizard - Wyse 3315SE Reference Manual

11

Initial Terminal Setup

Using the Setup Wizard

The Setup Wizard is used for initial setup of the terminal's properties. The wizard
runs when:
• You power-up your terminal for the first time.
Your terminal has been restarted with a G key reset (described later).
•
• A new image has been downloaded to your terminal but is older than the image
currently in use.
You use the Reset the Terminal to Factory-Default Property Settings
•
function on the General properties sheet.
The Setup Wizard lets you set terminal network configuration and terminal display
parameters. Any future changes can be made using the Terminal Properties
dialog box. You can launch this dialog box from the Winterm Connection
Manager by pressing the F2 key. See "Resetting Terminal Properties."
There are seven dialog boxes that display in succession during the process. Each
dialog box is self-explanatory. Some dialog boxes are informational and require no
user input. Other dialog boxes will prompt you for network and display information.
Following are the seven dialog boxes of the wizard.