33
SNMP Upgrades
Manual SNMP Firmware Upgrades
1. Ensure that the Wyse custom MIB (Management Information Base) is compiled
by your SNMP manager.
2. Enable SNMP Update Enable if it is not enabled.
3. Using the SNMP/Network Administrator dialog box, verify that the community
and set community names for the terminal match the community and set
community names in the SNMP manager.
Note
In order to initiate an SNMP upgrade, you must know
the FTP or TFTP server's IP address or machine name,
and the absolute path to the image on the FTP or TFTP
server.
Note
In the Wyse custom MIB the enterprise number for
Wyse is 1.3.6.1.4.1.714. Therefore, in this section
Wyse is equivalent to 1.3.6.1.4.1.714.
Note
You can set the Set Community name for a terminal if
you have DHCP enabled by setting DHCP Option 164
to the set community name your SNMP manager uses.