36
Installation Procedures
Turning On the Terminal
Once the terminal is installed and all back panel connections have been made,
power it up. If the terminal is a 3315SE, press and release the power management
button. If the terminal is a 3320SE, it is powered-up and operating when the power
supply is connected to AC power; to toggle the display off or on, press and release
the power management button.
See the following figure for the location of the power management button.
Figure 6-6 3315SE/3320SE Power Management Button
The logo will appear on the screen, followed by:
•
The Setup Wizard, if it is the first time that you have turned on your terminal.
•
The Winterm Connection Manager dialog box, if the Setup Wizard has been
completed.
If desired, adjust the display's geometry and intensities to your preferences.
Adjustments to the display can be made at any time, whether or not the terminal is
connected to a server. See "Changing Terminal Properties" for more information.
Note
For the 3320SE, if the button is continuously depressed
for 3-5 seconds, the unit will perform a hard boot.
Power
Management
Button