Using The Configuration Of Serial Cable On Com1 Dialog Box; Configuration Of Serial Cable On Com1 Dialog Box - Wyse 3315SE Reference Manual

140
Connection Configuration

Using the Configuration of Serial Cable on Com1 Dialog Box

The Configure command button invokes the Configuration of Serial Cable on
Com1 dialog box. Figure 27-7 shows this dialog box.
Figure 27-7 Configuration of Serial Cable on Com1 Dialog Box
The following table discusses this dialog box.
Table 27-4 Configuration of Serial Cable on Com1 Dialog Box
Function
Configuration of a
Serial Cable on
Com1
Local Echo
Description
Use these functions to configure a serial cable:
• Baud Rate
• Parity
• Flow Control
• Data Bits
• Stop Bits
• Transmit Limit
Each is presented as a drop-down scroll list. Click on
the upper-right down arrow to display the list and select
a value. The defaults are listed (consecutive to the
Function list to the left) as follows:
9600
•
• None
• Input
• 8
• 1
• Unlimited
Click on this check box to enable local echo.