DAP-1360 Wireless N300 Access Point & Router
User Manual
LAN
To configure the access point's local interface, proceed to the Net / LAN page.
If needed, edit the basic settings of the local interface.
Parameter
IP Address
Netmask
When needed settings are configured, click the Apply button.
In the DHCP server section, you can configure the built-in DHCP server of the access point. In
the router mode, the DHCP server is enabled by default.
Parameter
Mode
Figure 165. Basic settings of the local interface.
The IP address of the access point in the local subnet. By default, the
following value is specified: 192.168.0.50.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Figure 166. The section for configuring the DHCP server.
An operating mode of the access point's DHCP server.
Enable: the access point assigns IP addresses to clients
automatically in accordance with the specified parameters. When
this value is selected, the DNS Relay, Start IP, End IP, Gateway
IP address, and the Lease time fields are displayed on the page.
Disable: the access point's DHCP server is disabled, clients' IP
addresses are assigned manually.
Relay: an external DHCP server is used to assign IP addresses to
clients. When this value is selected, the External DHCP server IP
field is displayed on the page.
Page 207 of 270
Configuring Device (Router Mode)
Description
Description