Net; Lan - D-Link DAP-1360 User Manual

DAP-1360 Wireless N300 Access Point & Router
User Manual

Net

In this menu you can configure basic parameters of the local area network of the

LAN

To configure the access
If needed, edit the basic settings of the local interface.
Parameter
IP Address
Netmask
Gateway IP address
When needed settings are configured, click the Apply button.
In the DHCP server section, you can configure the built-in DHCP server of the access point. In
the access point mode, the DHCP server is disabled by default.
point's local interface, proceed to the Net / LAN page.
Figure 36. Basic settings of the local interface.
The IP address of the
following value is specified: 192.168.0.50.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
The gateway IP address which is used by the access point to connect
to the Internet
server). Optional.
Figure 37. The section for configuring the DHCP server.
Page 48 of 270
Description
access point in the local subnet. By default, the
(e.g., for synchronizing the system time with an NTP
Configuring Device (Access Point Mode)
access point.